Fully upholstered moulded foam lecture theatre chairs with a square timber base, lumber support, optional indentation to backrest, writing ledge and modesty panels on the front row.
*All measurements are as standard but can be adjusted to suit your requirements.
420mm* front to back, 90mm* thick CMHR 50 foam, supported on a 12mm* plywood base and fitted with a jacket cover in selected material. Underside is 12mm* birch plywood, fitted to cover seat brackets, upholstered or finished to colour of choice.
50mm* thick CMHR 35 foam, supported on a 12mm* plywood base. Back meets underside of the ledge above, the centre of the back has a “pull through” to create a feature line and is shaped using “wedged” foam to offer additional lumbar support. Outside back finished with 3mm* capping and fitted with a jacket cover in selected material.
Constructed from hollow section steel and plate with pivot action complete with nylon bush and silencer buffer seat brackets to BS5216 ND/3. All steelwork is powder coated to RAL 7016 anthracite grey or RAL 9005 black as standard.
290mm* wide, manufactured from 18mm* MDF board with plastic laminate and matching edges.
400mm* high, manufactured from 18mm* MDF board with plastic laminate and matching edges.
Covering material to be selected from standard range.
Outside backs and under-seat bottoms can be supplied with 3mm* clear lacquer birch plywood panels as against fully upholstered at no additional cost. Full depth extended backs.