Lecture Theatre Seating | LT-7
LT7 Lecture Chairs
LT7 Lecture Seating comes with a fully upholstered and moulded foam lecture theatre chair supported on a square timber base. Lumber support, optional indentation to the backrest and a writing ledge accompany these seats with modesty panels fitted on the front row.
For more information on these lecture chairs, see the drop downs below or contact us.
*All measurements are as standard but can be adjusted to suit your requirements.
Seat
440mm* front to back, 90mm* thick CMHR 50* foam supported on a 12mm* plywood base and covered in selected material. Underside finished with 9mm* thick plywood panel concealing brackets.
Back
425mm* top to bottom, 30mm* CMHR 35F* foam with 25mm* lumber, supported on a 12mm* plywood base. The centre of the back has a “pull through” to create a feature line. Fitted with a jacket cover in selected material.
Stanchions
Constructed from hollow section steel and plate with Pivot action complete with nylon bush and silencer buffer seat brackets to BS5216 ND/3 and partially concealed welds. All steelwork is powder coated to RAL 7016 anthracite grey or RAL 9005 black as standard.
Ledge
290mm* wide, manufactured from 18mm* MDF board with plastic laminate and high pressure matching or contrasting edges.
Modesty panels
600mm* high, manufactured from 18mm* MDF board with plastic laminate and high pressure matching or contrasting edges.
Material
Covering material to be selected from standard range.
Options
Outside backs and under-seat bottoms can be supplied with 3mm* clear lacquer birch plywood panels as against fully upholstered at no additional cost. Full depth extended backs.