Fully upholstered cut foam chair on a retractable unit, available with or without armrests and also in a fixed format.
*All measurements are as standard but can be adjusted to suit your requirements.
440mm* front to back, upholstered 40mm* thick CMHR 60 foam cushion, supported on a high-density birch plywood base and fitted with a jacket cover in selected material.
300mm* top to bottom, upholstered 32mm* thick CMHR 35 foam cushion, supported on a high-density birch plywood base and fitted with a jacket cover in selected material.
Constructed from hollow section 40 x 40 (20)* steel and plate, complete with sprung “auto-tip” seat brackets to BS5216 ND/3. All steelwork is powder coated to RAL 7016 anthracite grey or RAL 9005 black as standard.
230mm* in length with top and sides covered in CMHR foam and selected material.
Covering material to be selected from standard range.
Outside backs and under-seat bottoms can be supplied with 3mm* clear lacquer birch plywood panels as against fully upholstered at no additional cost. Seat numbers and row letters.