Fully upholstered, contoured moulded foam chair on a retractable unit, available with or without armrests and also in a fixed format.
*All measurements are as standard but can be adjusted to suit your requirements.
460mm* front to back, upholstered 60mm* thick CMHR 60* contoured foam cushion, supported on a high-density birch 12mm* plywood base. Underside finished with a 6mm* capping and fitted with a jacket cover in selected material.
500mm* top to bottom, upholstered and anatomically contoured 50mm* thick CMHR 35F* foam cushion, supported on a high-density birch plywood base, outside back finished with 6mm* capping and fitted with a jacket cover in selected material.
Constructed from 40mm* x 20mm* (40) hollow section steel and plate, complete with sprung ‘auto-tip’ seat brackets to BS5216 ND/3. All steelwork is powder coated to RAL 7016 anthracite grey or RAL 9005 black as standard.
250mm* in length with top and sides covered in CMHR foam and selected material.
Covering material to be selected from standard range.
Outside backs and under-seat bottoms can be supplied with 3mm* clear lacquer birch plywood panels as against fully upholstered at no additional cost. Wooden arms, high backs, seat numbers and row letters.