Retractable Seating | RS-6
The RS 6 is a fully upholstered, rounded and moulded foam chair on a retractable unit, available with or without armrests and also in a fixed format.
*All measurements are as standard but can be adjusted to suit your requirements.
450mm* front to back, upholstered 60mm* thick CMHR 60* foam cushion, supported on a 12mm* thick high-density birch plywood base curved back to front for comfort and covered in selected material. Underside is 3mm* plywood and 8mm* foam capping finished in matching material.
470mm* top to bottom, upholstered and anatomically contoured CMHR 50* foam cushion, supported on a 10mm* thick high-density birch plywood base curved side to side. Outside back finished with 6mm* capping and covered in selected material.
250mm* in length with profiled side panels in 12mm* plywood. Top and sides covered with CMHR foam and selected material.
Constructed from hollow section steel and plate, complete with sprung ‘auto-tip’ seat brackets to BS5216 ND/3. All steelwork is powder coated to RAL 7016 anthracite grey or RAL 9005 black as standard.
Covering material to be selected from standard range.
Outside backs and under-seat bottoms can be supplied with 3mm* clear lacquer birch plywood panels as against fully upholstered at no additional cost. Wooden arms, high backs, seat numbers and row letters.